Danfoss VLT AutomationDrive FC 300 Programming Guide

Contents
1 Introduction
3
Approvals 3
Symbols 3
Abbreviations 4
Definitions 4
Electrical wiring - Control Cables 11
2 How to Programme 15
The Graphical and Numerical Local Control Panels 15
How to Programme on the Graphical LCP 15
The LCD-Display 15
Display Mode 18
Display Mode - Selection of Read-Outs 19
Parameter Set-Up 20
Quick Menu Key Functions 21
Main Menu Mode 23
Parameter Selection 23
Infinitely Variable Change of Numeric Data Value 24
Read-out and Programming of Indexed Parameters 25
How to Programme on the Numerical Local Control Panel 26
Local Control Keys 27
Initialisation to Default Settings 28
3 Parameter descriptions 29
Parameters: Operation and Display 30
Parameters: Load and Motor 45
Parameters: Brakes 65
Parameters: Reference/Ramps 71
Parameters: Limits/Warnings 85
Parameters: Digital In/Out 92
Parameters: Analog In/Out 116
Parameters: Controllers 128
Parameters: Communications and Options 135
Parameters: Profibus 150
Parameters: DeviceNet CAN Fieldbus 162
Parameters: Ethernet 169
Parameters: Smart Logic Control 176
Parameters: Special Functions 194
Parameters: Drive Information 205
Parameters: Data Read-outs 212
FC 300 Programming Guide Contents
MG.33.M8.02 - VLT
®
is a registered Danfoss trademark 1

Danfoss VLT AutomationDrive FC 300 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 300
Category	DC Drives
Language	English