Danfoss VLT AutomationDrive FC 300 Programming Guide

Main Menu/ Quick Setup is used for programming all parameters or
only the parameters in the Quick Meny (see also description of the LCP
102 earlier in this chapter).
The parameter values can be changed using the [
▲
] [
▼
] keys when the
value is flashing.
Select Main Menu by pressing [Menu] key a number of times.
Select the parameter group [xx-__] and press [OK]
Select the parameter [__-xx] and press [OK]
If the parameter is an array parameter select the array number and press
[OK]
Select the wanted data value and press [OK]
Parameters with functional choices display values such as [1], [2], etc.
For a description of the different choices, see the individual description
of the parameters in the
Parameter Selection section
[Back] for stepping backwards
Arrow [
▲
] [
▼
] keys are used for manoeuvring between commands and
within parameters.
2.1.18 Local Control Keys
Keys for local control are found at the bottom of the LCP.
[Hand on] enables control of the frequency converter via the LCP. [Hand on] also starts the motor and it is now possible to enter the motor speed data
by means of the arrow keys. The key can be selected as Enable [1] og Disable [0] via par. 0-40
[Hand on] Key on LCP .
External stop signals activated by means of control signals or a serial bus will override a 'start' command via the LCP.
The following control signals will still be active when [Hand on] is activated:
• [Hand on] - [Off] - [Auto on]
• Reset
• Coasting stop inverse
•Reversing
• Set-up select lsb - Set-up select msb
• Stop command from serial communication
•Quick stop
•DC brake
FC 300 Programming Guide 2 How to Programme
MG.33.M8.02 - VLT
®
is a registered Danfoss trademark 27
2

Danfoss VLT AutomationDrive FC 300 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 300
Category	DC Drives
Language	English