Danfoss VLT AutomationDrive FC 361 Series User Manual

1 Introduction
1.1 Purpose of the Design Guide
This design guide is intended for:
•
Project and systems engineers.
•
Design consultants.
•
Application and product specialists.
The design guide provides technical information to
understand the capabilities of the drive for integration into
motor control and monitoring systems.
VLT
®
is a registered trademark.
1.2 Additional Resources
Other resources are available to understand advanced
drive functions and programming.
•
The operating guide provides detailed information
for the installation and start-up of the drive.
•
The programming guide provides greater detail on
working with parameters and many application
examples.
•
Instructions for operation with optional
equipment.
Supplementary publications and manuals are available
from Danfoss. See
www.danfoss.com/en/search/?lter=type
%3Adocumentation%2Csegment%3Adds for listings.
1.3
Document and Software Version
This manual is regularly reviewed and updated. All
suggestions for improvement are welcome. Table 1.1 shows
the version of the manual and the corresponding software
version.
Manual version Remarks Software version
MG06K1xx First edition. 1.0x
Table 1.1 Manual and Software Version
1.4
Approvals and Certications
Drives are designed in compliance with the directives
described in this section.
1.4.1 CE Mark
The CE mark (Conformité Européenne) indicates that the
product manufacturer conforms to all applicable EU
directives.
The EU directives applicable to the design and
manufacture of drives are:
•
The Low Voltage Directive.
•
The EMC Directive.
•
The Machinery Directive (for units with an
integrated safety function).
The CE mark is intended to eliminate technical barriers to
free trade between the EC and EFTA states inside the ECU.
The CE mark does not regulate the quality of the product.
Technical specications cannot be deduced from the CE
mark.
1.4.2 Low Voltage Directive
Drives are classied as electronic components and must be
CE-labeled in accordance with the Low Voltage Directive.
The directive applies to all electrical equipment in the 50–
1000 V AC and the 75–1500 V DC voltage ranges.
The directive mandates that the equipment design must
ensure the safety and health of people and livestock, and
the preservation of material by ensuring the equipment is
properly installed, maintained, and used as intended.
Danfoss CE labels comply with the Low Voltage Directive,
and Danfoss provides a declaration of conformity upon
request.
Introduction VLT® AutomationDrive FC 361
4 Danfoss A/S © 03/2019 All rights reserved. MG06K102
11

Danfoss VLT AutomationDrive FC 361 Series Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 361 Series
Category	DC Drives
Language	English