WARNING
EQUIPMENT HAZARD
Contact with rotating shafts and electrical equipment
can result in death or serious injury.
•
Ensure that only trained and qualied personnel
install, start up, and maintain the drive.
•
Ensure that electrical work conforms to national
and local electrical codes.
•
Follow the procedures in this guide.
WARNING
UNINTENDED MOTOR ROTATION
WINDMILLING
Unintended rotation of permanent magnet motors
creates voltage and can charge the unit, resulting in
death, serious injury, or equipment damage.
•
Ensure that permanent magnet motors are
blocked to prevent unintended rotation.
WARNING
INTERNAL FAILURE HAZARD
Under certain circumstances, an internal failure can
cause a component to explode. Failure to keep the
enclosure closed and properly secured can cause death
or serious injury.
•
Do not operate the drive with the door open or
panels o.
•
Ensure that the enclosure is properly closed and
secured during operation.
CAUTION
HOT SURFACES
The drive contains metal components that are still hot
even after the drive has been powered o. Failure to
observe the high temperature symbol (yellow triangle)
on the drive can result in serious burns.
•
Be aware that internal components, such as
busbars, can be extremely hot even after the
drive has been powered o.
•
Exterior areas marked by the high-temperature
symbol (yellow triangle) are hot while the drive
is in use and immediately after being powered
o.
Safety Operating Guide
MG06I102 Danfoss A/S © 06/2018 All rights reserved. 5
2 2
To Next Page
Loading...
Need help?
General