Danfoss VLT FC 100 User Manual

Ordering Information
Rittal TS-8 Enclo-
sure
Frame D3 Kit Part
No.
Frame D4 Kit Part
No.
Frame E2 Part No.
70.9 in [1800 mm] 176F1824 176F1823 Not possible
78.7 in [2000 mm] 176F1826 176F1825 176F1850
86.6 in [2200 mm] 176F0299
Kit Contents
• Ductwork components
• Mounting hardware
• Gasket material
• Delivered with D1 and D2 frame kits:
• 175R5639 - Mounting templates and top/bottom cut-out for Rittal enclosure.
• Delivered with E1 frame kits:
• 175R1036 - Mounting templates and top/bottom cut-out for Rittal enclosure.
All fasteners are either:
• 0.39 in [10 mm], M5 Nuts torque to 2.3 Nm (20 in-lbs)
• T25 Torx screws torque to 2.3 Nm (20 in-lbs)
3.4.1. Installation of Rittal Enclosures
This illustration shows the full size template
included with the kit and two drawings that
may be used to locate the cut-outs for the top
and bottom enclosure plates. The duct work
may also be used to locate the openings.
3.29: Templates
VLT
®
Automation Drive FC 300
Instruction Manual High Power
3. How to Install
MG.33.U1.22 - VLT
®
is a registered Danfoss trademark. 37
3

Danfoss VLT FC 100 Specifications

General

Brand	Danfoss
Model	VLT FC 100
Category	DC Drives
Language	English