Danfoss VLT FC 100 User Manual

3-02 Minimum Reference
Range: Function:
0.000
Unit
*
[-100000.000 - par.
3-03]
The Minimum reference is the minimum value obtained by the
sum of all references.
Minimum reference is only active if Min -
Max
[0] is set in par. 3-00.
3-03 Maximum Reference
Range: Function:
1500.00
0
*
[Par. 3-02 -
100000.000]
Enter the maximum reference. The maximum reference is the
highest value obtainable by adding all references together.
The Maximum Reference unit matches:
• The choice of configuration in par. 1-00
Configuration
Mode
: for Speed closed-loop [1], RPM; for Torque [2],
Nm.
• The unit selected in par. 3-01
Reference/Feedback
Unit
.
3-41 Ramp 1 Ramp-up Time
Range: Function:
s
*
[0.01 - 3600.00 s] Enter the ramp-up time, i.e., the acceleration time from 0 RPM
to the rated motor speed n
M,N
(par. 1-25). Choose a ramp-up
time such that the output current does not exceed the current
limit in par. 4-18 during ramping. The value 0.00 corresponds
to 0.01 sec. in speed mode. See ramp-down time in par. 3-42.
Par .3− 41 =
t
acc
s ×n
M , N
(
par .1− 25
)
RPM
Δ ref RPM
4. How to Program
VLT
®
Automation Drive FC 300
Instruction Manual High Power
82 MG.33.U1.22 - VLT
®
is a registered Danfoss trademark.
4

Danfoss VLT FC 100 Specifications

General

Brand	Danfoss
Model	VLT FC 100
Category	DC Drives
Language	English