VLT
®
FCD Series
■ The LCP 2 control unit, option
The FCD 300 can be combined with an LCP control
unit (Local Control Panel - LCP 2) which makes up a
complete interface for operation and pro
gramming of
the frequency converter. The LCP 2 control unit can
be attached up to three metres from the frequency
converter, e.g. on a front panel, usin
g an accessory kit.
The control panel is divided into f
ive functional groups:
1. Display.
2. Keys used to change the display function.
3. Keys used to change the programme par
ameters.
4. Indicator lamps.
5. Local control keys.
Alldataisdisplayedviaa4-linealphanumeric
display, which during normal ope
ration will be able
to continuously display 4 items of operating data
and 3 operating modes. During programming all
information needed for quick,
effective parameter
setup of the frequency converter will be displayed. As
asupplementtothedisplay,therearethreeindicator
lamps for voltage (ON), w
arning (WARNING) and alarm
(ALARM). All frequency converter parameter Setups
can be changed immediately from the control panel,
unless this function h
as been programmed as Locked
[1] via parameter 018 Lock for data c hanges.
■ Control keys for parameter Setup
The control keys are divided into functions, in
such a way that the keys between the display
and the indicator lamps are used for parameter
Setup, including selection of the display’sview
mode during normal operation.
[DISPLAY/STATUS] is used to select the display’s
view mode or to change back to Display mode
from either Quick Menu or Menu mode.
[QUICK MENU] provides access to the parameters
used in the Quick Menu. It is possible to switch
between Quick Menu and Menu mode.
[MENU] givesaccesstoallparameters. Itispossible
to switch between Menu mode and Quick Menu.
[CHANGE DATA] is used to change a parameter that
has been selected either in Menu mode or Quick Menu.
[CANCEL] is used if a change to the selected
parameter is not to be implemented.
[OK] is used to confirm a change to a
selected parameter.
[+ / -] are used for selecting parameters and
for changing parameter values.
These keys are also used in Display mode to switch
between the readouts of operating variables.
[< >] are used for selecting parameter group and to
move the cursor when changing a numerical value.
MG.04.B7.02 - VLT is a registered Danfoss trademark
26
To Next Page
Loading...
Need help?
General