Contents
1 Safety
4
1.1 Copyright, Limitation of Liability and Revision Rights
4
1.2 Safety Note
4
1.3 Safety Regulations
4
1.4 Warning against Uninteded Start
5
2 Introduction
6
2.1 About this Manual
6
2.2 Technical Overview
6
2.3 Assumptions
6
2.4 Hardware
6
2.5 Background Knowledge
6
2.6 Available Literature
6
2.7 Abbreviations
7
3 How to Install
8
3.1 Installation
8
3.1.1 How to Install Option in Frequency Converter 8
3.1.2 The PROFINET Interface for the FCD 302 9
3.1.3 Network 9
3.1.4 PROFINET Cables 10
3.1.5 Topology 11
3.1.6 Recommended Design Rules 14
3.1.7 EMC Precautions 15
3.2 Using the Hardware Switches
15
3.3 LED Behaviour
16
4 PROFINET Parameters
18
4.1 Settings Communication Parameters
18
4.2 Ethernet Link Parameters
19
5 How to Configure the System
20
5.1 Configure the PROFINET Network
20
5.2 Configure the Controller
20
5.2.1 GSD File 20
5.3 Configure the Frequency Converter
23
5.3.1 VLT Parameters 23
6 How to Control the Frequency Converter
24
6.1 PPO Types
24
6.2 PCV Parameter Access
26
Contents Operating Instructions
MG90U302 Danfoss A/S © Rev. 2014-02-27 All rights reserved. 1
To Next Page
Loading...
Need help?
General