Datacard® SR200 & SR300 Printer
Hardware and Driver Installation Manual 5
Installing the Card Stacker
Card Stacker on SR200 or SR300 Printer
For the SR200 or SR300 printer, hang the stacker tabs on the stacker attachment slots as
shown in the following figure. Be sure to hang the card stacker attachment tabs on the card
stacker attachment slots, not on the card discharge slot.
Installing a Smart Card Driver
If the printer has a Contact IC Enc/ R/W option installed, install the driver for the
smart card reader before installing the printer driver. The driver installation
interface includes a link to the driver location.
To download the driver without using the Support CD:
1. Using your web browser, go to http://support.gemalto.com.
2. Choose PC-Link Readers > PC-USB TR and PC TWIN.
3. From the list, choose your operating system, language, and architecture (32-bit or
64-bit). Also, choose drivers for USB, not a serial connection.
For example, for English-language Windows Vista 32-bit, USB connection,
you would choose the following:
The card hopper can hold up to 100 0.030 inch (0.76mm) thick cards or 280
0.010 inch (0.25mm) thick cards.
To Next Page
Loading...
Need help?
General
