Getting Started
Ovation2 5
The printer can also be connected to the host with a parallel
connection. In addition, the printer has a unique feature where if you
connect both the serial and parallel cables to the printer at the same
time, the printer will automatically interface to the first connection,
(serial or parallel) that transmits valid data. After a connection has
been made, the printer must be turned off and then back on again to
change the interface connection.
1.6 Loading Media
1. Open the cover.
2. Push the printhead latch toward the back of the printer and raise
the printhead carrier assembly.
3. Place a roll of media (labels facing up) on the media hub and
insert them into the printer. Slide the media hub against the roll of
media
4. Pull 6″ (152 mm) of media from the media roll in the printer.
5. Slide the media guide to the edge of the media.
6. Close the printhead carrier assembly and press down until it locks
into place.
Figure 1-5 Loading Media
7. Close the cover and press the ‘Feed’ Button several times to feed the
media and ensure proper tracking.
Note: The printer is factory set for 4-inch media and ribbon, when using
different width media/ribbon please refer to Section 1.9.
To Next Page
Loading...
Need help?
General