Steps
1. Insert the camera into the slot on the display back cover.
2. Adhere the adhesive tape and secure the camera in place.
3. Connect the camera cable to the connector.
Next steps
1. Install the display bezel.
2. Install the display assembly.
3. Install the WWAN for 4G LTE enabled systems.
4. Install the base cover.
5. Follow the procedure in after working inside your computer.
Display hinges
Removing the display hinges
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the WWAN card for 4G LTE enabled systems.
4. Remove the display assembly.
5. Remove the display bezel.
6. Remove the display panel.
About this task
The following image indicates the location of the display hinges and provides a visual representation of the removal procedure.
52
Removing and installing components