Back to Contents Page
Bottom of the Base Assembly
Dell™Latitude™E5400andE5500ServiceManual
Removing the E5400 Bottom of the Base Assembly
Replacing the E5400 Bottom of the Base Assembly
Removing the E5500 Bottom of the Base Assembly
Replacing the E5500 Bottom of the Base Assembly
Removing the E5400 Bottom of the Base Assembly
1. Follow the procedures in Before Working on Your Computer.
2. Close the display and turn the computer upside down.
3. Loosen the five captive screws securing the bottom of the base assembly.
4. Pry up on the recess near the slender edge where indicated and slide the bottom of the base assembly toward the left side of the computer, and lift it
up.
Replacing the E5400 Bottom of the Base Assembly
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer. For additional
safety best practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer. For additional
safety best practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.