Replacing the display cable
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Route the display cable through the routing guides on the display panel.
2 Slide the display cable into the connector and press down the latch to secure the
cable.
3 Slide the sensor-board cable into the connector on the sensor board and press
down the latch to secure the cable.
4 Adhere the sensor-board cable tape.
5 Adhere the tape that secures the display cable to the display panel.
Post-requisites
1 Follow the procedure from step 4 to step 6 in “Replacing the display panel”.
2 Replace the display assembly.
3 Replace the camera.
4 Replace the battery.
5 Replace the base cover.
98
To Next Page
Loading...
Need help?
General