To Next Page

To Previous Page



Connecting and Disconnecting Drive Cables



When removing an IDE drive data cable, grasp the colored pull tab and pull until the connector detaches.



When connecting and disconnecting a serial ATA data cable, hold the cable by the black connector at each end.



Like IDE connectors, the serial ATA interface connectors are keyed for correct insertion; that is, a notch or a missing pin on one connector matches a tab or a

filled-in hole on the other connector.



Hard Drive



1. If you are replacing a hard drive that contains data you want to keep, back up your files before you begin this procedure.

2. Check the documentation for the drive to verify that it is configured for your computer.

3. Follow the procedures in "Before You Begin."



Removing a Hard Drive

1. Disconnect the power and hard-drive cables from the drive.



power cable

power input connector

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.

NOTICE: To avoid damage to the drive, do not set it on a hard surface. Instead, set the drive on a surface, such as a foam pad, that will sufficiently

cushion it.