9. Follow the procedure in After working inside your computer.
Camera assembly
Removing the camera module
CAUTION: The information in this section is intended for authorized service technicians only.
NOTE: This procedure is applicable for systems shipped with a plastic chassis only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
4. Remove the wireless card.
5. Remove the display assembly.
6. Remove the hinge caps.
7. Remove the display bezel.
8. Remove the hinges.
9. Remove the display panel.
About this task
The following images indicate the location of the camera module and provide a visual representation of the removal procedure.
Steps
1. Using the pull tab, disconnect the camera cable from the camera module.
2. Using a plastic scribe, pry the camera module from the display assembly.
116
Removing and installing Field Replaceable Units (FRUs)
117 / 156 116 / 154 117 / 156
To Next Page
Loading...
Need help?
General
