NOTE: Ensure that you fold the keyboard data cable in perfect alignment.
3. Install the:
a. battery
b. base cover
c. SD card
4. Follow the procedure in After working inside your computer.
Primary memory module
Removing the primary memory module
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. SD card
b. base cover
c. battery
d. keyboard
3. To remove primary memory module:
a. Remove the single (M2.0x3.0) screw that secures the memory shield [1].
b. Slide and lift the memory shield from the memory module on the system [2].
c. Pry the retention clips away from the memory module until it pops up [3].
d. Lift the memory module and remove it from the system [4].
NOTE: Repeat step (c) and (d) if there is another memory installed.
Removing and installing components 29
To Next Page
Loading...
Need help?
General
