c. Remove the 2 (M2.0x5.0) screws that secure the graphics card to the system board [3].
d. Remove the graphics card from the system [4].
NOTE: The above procedures are for UMA graphics card. Systems shipped with UMA GPU card do not have GPU
power cable. However, for discrete models shipped with either a 128 MB or 256 MB VRAM GPU card, you need to
disconnect the GPU power cable before removing the GPU card.
Installing the graphics card
1. To Install the graphics card:
a. Slide the graphics card into its original position in the system [1].
b. Replace the 2 (M2.0x5.0) screws to secure the graphics card to the system board [2].
c. Replace the beam connector [3].
d. Replace the 2 (M2.0x3.0) screws to secure the beam connector to the system board [4].
74
Removing and installing components
To Next Page
Loading...
Need help?
General
