EasyManuals Logo
Home>Dell>Server>PowerEdge R510

Dell PowerEdge R510 User Manual

Dell PowerEdge R510
216 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #160 background imageLoading...
Page #160 background image
160 Installing System Components
Installing the SAS Backplane
1
Lower the backplane into the system, being careful to avoid damaging
components on the face of the board.
2
Align the slots in the backplane with the retention hooks on the back of
the drive bays, then move the backplane forward until the retention hooks
fit through the slots in the backplane. See Figure 3-35.
3
Slide the backplane downward until the two blue retention latches snap
into place.
4
Connect the SAS data and power cables to the SAS backplane.
5
Install the hard drives in their original locations.
6
Connect the optical drive cable, USB cable, and the control panel cable to
the system board.
CAUTION: Handle the cables gently to prevent damage.
NOTE: In case of the twelve–hard-drive systems, connect the internal
hard-drive cables.
7
Close the system. See "Closing the System" on page 89.
8
Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
book.book Page 160 Friday, November 20, 2009 2:56 PM

Table of Contents

Other manuals for Dell PowerEdge R510

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell PowerEdge R510 and is the answer not in the manual?

Dell PowerEdge R510 Specifications

General IconGeneral
HDD size3.5 \
Hot-swapYes
HDD capacity450 GB
HDD interfaceSerial Attached SCSI (SAS)
Total storage capacity900 GB
Number of HDDs installed2
Number of HDDs supported8
Internal memory4 GB
Memory clock speed1066 MHz
Internal memory typeDDR3-SDRAM
Maximum internal memory64 GB
Tcase76 °C
Bus typeQPI
SteppingD0
FSB ParityNo
Processor codeSLBF6
Processor cache8 MB
Processor cores4
Processor modelE5540
System bus rate5.86 GT/s
Processor seriesIntel Xeon 5500 Series
Processor socketSocket B (LGA 1366)
Processor codenameNehalem EP
Motherboard chipsetIntel® 5500
Processing Die size263 mm²
Processor frequency2.53 GHz
Processor cache typeSmart Cache
Processor lithography45 nm
Processor system typeDP
Processor manufacturerIntel
Processor package size42.5 x 45 mm
Processor front side bus- MHz
Processor boost frequency2.8 GHz
Processor operating modes64-bit
Thermal Design Power (TDP)80 W
CPU multiplier (bus/core ratio)19
Number of Processing Die Transistors731 M
Memory channels supported by processorTriple
Memory clock speeds supported by processor800, 1066 MHz
Memory bandwidth supported by processor (max)25.6 GB/s
Maximum internal memory supported by processor144 GB
PS/2 ports quantity0
Serial ports quantity1
USB 2.0 ports quantity6
DisplayLCD
L1 cache0.064 MB
Form factor-
Graphics cardG200eW
Dimensions (WxDxH)86.4 x 436.6 x 609.6 mm
Compatible operating systemsMicrosoft Windows Small Business Server 2008/2003/ Novell SUSE Linux Enterprise Server 11/10 SP2 Linux Red Hat Enterprise 5.3/4.7 VMware vSphere Version 4.0 VMware ESX v3.5 / ESXi v3.5
Power consumption (typical)1100 W
Noise level42 dB
Chassis typeRack (2U)
PCI Express x4 slots3
Processor ARK ID37104
Intel® Turbo Boost Technology1.0
Weight and Dimensions IconWeight and Dimensions
Weight13500 g

Related product manuals