Post Installation Tasks 41
2
Right-click the network connection you want to configure and select
Properties
.
3
On the
General
tab (for a local area connection) or the
Networking
tab
(for all other connections), select
Internet Protocol (TCP/IP)
, and then
click
Properties
.
4
Select
Advanced
WINS
tab and click
Add
.
5
In the
TCP/IP WINS server
window, type the IP address of the WINS
server and click
Add
.
6
To enable use of the Lmhosts file to resolve remote NetBIOS names, select
Enable LMHOSTS lookup
.
7
To specify the location of the file that you want to import into the
Lmhosts file, select
Import LMHOSTS
and then select the file in the
Open
dialog box.
8
Enable or disable NetBIOS over TCP/IP.
If using Microsoft Windows Server 2008 Core Version, use the netsh
interface command to configure the iSCSI ports on the host server.
Linux Host Setup
To set up a Linux host network, you must configure the IP address and
netmask of each iSCSI port connected to the storage array. The specific steps
depend on whether you are configuring TCP/IP using DHCP or configuring
TCP/IP using a static IP address.
NOTE: The server IP addresses must be configured for network communication to
the same IP subnet as the storage array management and iSCSI ports.
If you are using DHCP (root users only):
1
Edit the
/etc/sysconfig/network
file:
NETWORKING=yes HOSTNAME=mymachine.mycompany.com
book.book Page 41 Wednesday, December 29, 2010 9:23 PM
To Next Page
Loading...
Need help?
General