Steps
1. Place the power button into its slot on the computer.
2. Replace the two (M2x3) screws to secure the power button in place.
Next steps
1. Install the power button board.
2. Install the heat-sink assembly.
3. Install the battery.
4. Install the base cover.
5. Install the SD card.
6. Follow the procedure in after working inside your computer.
Power button assembly with fingerprint reader
Removing the power button assembly with fingerprint
reader
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
4. Remove the battery.
5. Remove the heat-sink assembly.
6. Remove the power button board assembly with fingerprint reader.
About this task
The figure indicates the location of the power button and provides a visual representation of the removal procedure.
58
Disassembly and reassembly
To Next Page
Loading...
Need help?
General