40
After about 30 minutes, the message "Rinsing
FILL TANK!" is displayed.
9. The appliance is now ready for rinsing
through with clean water.
Remove the water tank, empty, rinse under
running water, fill with clean water and repla-
ce. "Rinsing... Press OK" is displayed.
10. Empty the container used to collect the desca-
ler solution and replace it under the hot water
spout.
11. Press the OK button to start rinsing. Hot water
flows out of the spout and the message
"Rinsing..." is displayed.
12. When the water tank is completely empty, the
message "Rinsing complete... Press OK but-
ton?" is displayed.
13. Press the OK button, fill the water tank and the
appliance is ready for use.
SETTING WATER HARDNESS
The DESCALE message is displayed after a period
of time established according to water hardness.
The machine is factory set for a hardness value of
4 (very hard water).
The machine can also be programmed according
to the actual hardness of the mains water in the
various regions, varying the frequency with which
the message is displayed.
Measuring water hardness
1. Remove the "TOTAL HARDNESS TEST" indica-
tor paper from its pack.
2. Immerse the paper completely in a glass of
water for about a second.
3. Remove the paper from the water and shake
lightly.
After about a minute, 1, 2, 3, or 4 red squares
form, depending on the hardness of the water.
Each square corresponds to one level.
Setting water hardness
1. Press the P icon to enter the programming
menu.
2. Press the or icon and select "Water
hardness".
3. Confirm the selection by pressing the OK
icon.
4. Press the or icon to set the number of
squares formed on the reactive strip (see figu-
re in the previous section).
5. Press the OK icon to confirm the setting.
6. Press the ESC icon to exit the menu.
The machine is now reprogrammed with the new
water hardness setting.
TECHNICAL SPECIFICATION
Voltage: 220-240 V~ 50/60 Hz 10A max.
Absorbed power: 1350 W
Pressure: 15 bars
Water tank capacity: 1.8 litres
Size: LxHxD: 282x374x441 mm
Weight: 11.4 kg
The appliance complies with the following
EC directives:
• Low Voltage Directive 2006/95/EC;
• EMC Directive 89/336/EEC and subsequent
amendments 92/31/EEC and 93/68/EEC.
Materials and accessories coming into contact
with food conform to EC regulation 1935/2004.
DISPOSAL
Electrical appliances must not be disposed
of as household waste.
Appliances with this symbol are covered
by European Directive 2002/96/EC.
All unused electric and electronic appliances must
be disposed of separately from household waste
by taking them to the special centres provided by
the State.
Disposing of the unused appliance correctly
avoids damage to the environment and a risk to
health.
For more information on disposing of the unused
appliance, contact the local administration, the
waste disposal department or the shop where the
appliance was bought.
soft water
G
slightly hard wate
r
GG
hard water
GGG
very hard water
GGGG
To Next Page
Loading...
Need help?
General
