41
DISPLAYED MESSAGES
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
FILL TANK!
• The water tank is empty or
positioned incorrectly.
• Fill the tank with water and/or
insert it correctly, pushing it as
far as it will go.
GROUND TOO FINE ADJUST
MILL!
Insert water spout and press
OK
• The grinding is too fine and the
coffee is delivered too slowly.
• The machine cannot make cof-
fee as there is air in the hydrau-
lic circuit
• - Make the coffee again and
turn the grinding adjustment
knob one click clockwise
towards "7" while the coffee
mill is in operation. The effect
is only visible after delivering
two coffees.
• Press the OK icon to deliver
water from the spout until it
flows out normally.
INSERT WATER SPOUT!
• The water spout is not inserted
or is inserted incorrectly.
EMPTY GROUNDS CONTAINER
• The grounds container is too
full or more than 3 days have
passed since you last made
coffee (this guarantees correct
hygiene of the machine).
• Empty the grounds container
and clean, then replace.
Important: when removing the
drip tray, the grounds container
MUST be emptied, even if it is
not completely full.
If this is not done, when you
make the next coffees, the
grounds container may fill up
more than expected and clog
the machine.
INSERT GROUNDS
CONTAINER
• After cleaning, the grounds
container has not been
replaced.
• Open the service door and
insert the grounds container.
INSERT MILK CONTAINER!
• The milk container is not inser-
ted.
• Insert milk container as far as it
will go.
• Insert water spout as far as it
will go.
DESCALE!
• The machine must be descaled. • The descaling procedure
described in the "Descaling"
section needs to be performed
as soon as possible.
LESS COFFEE!
• Too much coffee has been
used.
• Select a milder taste or reduce
the quantity of pre-ground cof-
fee, then make the coffee again.
To Next Page
Loading...
Need help?
General
