34
3. As soon as the coffee in the cup reaches the
required level, press the icon again.
The quantity set has now been programmed.
N.B.!
This setting is valid for making both
one and two cups. You do not need to specifically
programme a quantity for two cups.
Programming the long "my coffee"
quantity
The appliance is set by default to automatically
deliver ≃100ml of LONG coffee. To modify this
quantity, proceed as follows:
1. Press the icon repeatedly (fig. 8) until
"MY COFFEE" is displayed.
2. Press the LONG icon (fig. 10) until
"Program quantity" is displayed, then release.
The machine starts delivering the coffee and
the LONG icon flashes;
3. As soon as the coffee in the cup reaches the
required level, press the LONG icon again.
The quantity set has now been programmed.
Regulating the coffee mill
The coffee mill is preset in the factory to prepare
coffee correctly and should not require regulating
initially.
However, if after making the first few coffees you
find that delivery is either too fast or too slow (a
drop at a time), this can be corrected by regula-
ting the grinding adjustment knob (fig. 11).
Important!
The grinding coarseness regu-
lator must only be turned when the coffee mill is
in operation.
For slower coffee deli-
very and a creamier cof-
fee, turn one click
towards "1" (finer
ground coffee).
For more rapid coffee
delivery (not in drops),
turn one click towards
"7" (coarser ground cof-
fee).
N.B.!
These adjustments will only be evi-
dent after at least two cups of coffee have been
made.
Making espresso coffee using
coffee beans
Important!
Do not use caramelised or
candied coffee beans as they could stick to the
coffee mill and make it unusable.
1. Fill the container with coffee beans (fig. 12).
2. Place under the coffee spouts:
- one cup, if you want one coffee (fig. 13);
- two cups, if you want two coffees (fig. 14);
3. Lower the spouts as near as possible to the
cup. This makes a creamier coffee (fig. 15).
4. Press the icon corresponding to the number
of coffees required (one cup or two cups
) (fig. 9 and 16).
5. Preparation begins. A progress bar appears
on the display and gradually advances as the
procedure progresses (fig. 17).
Once the coffee has been made, the appliance is
ready to use again.
N.B.!
• While the machine is making coffee, delivery
can be interrupted at any moment by pressing
the lit cup icon.
• At the end of delivery (when the progress bar
is complete), to increase the quantity of coffee
in the cup, just press (within 3 seconds) one
of the coffee icons ( or ) until the
required quantity is reached.
• For a hotter coffee, before delivery rinse the
appliance through by pressing the icon
and confirming with the OK icon. Hot water
flows out of the coffee spouts and heats the
internal circuit of the machine so that the cof-
fee delivered will be hotter.
• For an even hotter coffee, heat the cups by
rinsing them with the hot water.
• If the coffee is delivered in drops, too fast and
not creamy enough or too cold, read the tips
in the "Troubleshooting" section on page 43.
Making long coffee using coffee
beans
N.B.!
When this function is activated, a
long coffee similar to drip coffee is obtained.
Important!
Do not use caramelised or
candied coffee beans as they could stick to the
coffee mill and make it unusable.
To Next Page
Loading...
Need help?
General
