4.9 Wiring Analog Input/Output Modules
Definitions of the terminals
◆ Two/three-wire (passive sensor): the sensor and the system share the same power circuit.
◆ Four-wire (active sensor): the sensor uses an independent power supply and should not share the
same power circuit with the system.
◆ Note: use cables with the same length (less than 200 m) and use terminal resistors of less than 100
ohm.
4.9.1 Wiring AS04AD-A
Shi elded cabl e *1
-10 V~+10V
V I+
I1+
VI1-
CHX
V 3+
I3+
V I3-
*3
* 2
CH1
1M
CH3
AG
1M
1M
A G
1M
25 0
25 0
0V
24 V
24 VD C
DC/DC
Conve rter
+15V
-15 V
A G
FE
*4
*5
+
-
-20 mA ~+20 mA
V 2+
I2+
V I2-
* 2
CH2
1M
A G
1M
25 0
*4
FE
+
-
+
-
+24V
0V
V4+
I4+
V I4-
CH4
1M
A G
1M
25 0
+24V
0V
4mA ~+20m A
CH1
1M
A G
1M
25 0
-20mA~+20 mA
+24V
+
-
V 1+
I1+
V I1-
*2
-10 V~+10V
+24V
+
-
* 4
FE
*4
FE
*4
FE
0V
+24V
0V
0V
*6
CHX
*6
CHX
* 6
CHX
*6
CHX
* 6
Shi elded cabl e *1
Shi elded cabl e *1
Shi elded cabl e *1
Shi elded cabl e *1
4-wir e: voltage input
4-wir e: curr ent inp ut
2-wire: current inp ut
3-wire: voltag e inpu t
2-wire: current inp ut
3-wire: cur rent inpu t
*1. Use shielded cables to isolate the analog input signal cable from other power cables.
*2. If the module is connected to a current signal, the terminals Vn and In+ (n=1–4) must be short-circuited.
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
To Next Page
Loading...
Need help?
General
