A. Right click the AS300 Series PLC icon in HWCONFIG, then click Communication Software, and
then click CANopen Builder.
B. IF AS300 is in master mode, you can skip this step. If not, you can go to Properites and set it in
Master mode. After that download the parameter to AS300. Set AS300 Power off for 2 seconds
and supply power again and then proceed to the next step.
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
To Next Page
Loading...
Need help?
General
