Denon AVR-1912E3 User Manual

25
3. Remote ID Setup mode
3.1. Specications
When using multiple DENON AV receivers in the same room, make this setting so that only the desired AV receiver
operates.
When you change the remote ID, make sure that the remote control unit and the remote ID of the main unit are exactly
the same.
3.2. Setting the AV receivers
Starting up:
Turn on the power, then press and hold down the "STATUS" and " PRESET CHANNEL 1 " buttons for over 3 seconds.
(1) When Remote ID Setup mode is started, the following is displayed.
FLD
R E M O T E I D ?
(2) Press the "QUICK SELECT 1 - 4" button that corresponds to the number you want to set.
Button FL Display
QUICK SELECT 1
R E M O T E I D 1
QUICK SELECT 2
R E M O T E I D 2
QUICK SELECT 3
R E M O T E I D 3
QUICK SELECT 4
R E M O T E I D 4
(3) Turn off the power using "ON/STANDBY" button.
(4) Turn on the power using "ON/STANDBY" button.
b
When Remote ID Setup mode is running, operations other than the "QUICK SELECT 1 - 4" buttons or "ON/
STANDBY" buttons on the main unit are not received.
3.3. Setting the Remote control unit
(1) Press and hold both "ZONE/DEVICE (1)" button for over 3 seconds.
The zone mode indicator ashes twice.
(2) Press the "AMP" button.
The zone mode indicator ashes twice.
(3) Press the "1, 2, 3 or 4" button.
s
The zone mode indicator ashes twice.
NOTE:
If the IDs do not match, "AVAMP
z
" (
z
is the main unit's remote control ID) appears on the display when the remote
control unit is operated.

Denon AVR-1912E3 Specifications

General

Brand	Denon
Model	AVR-1912E3
Category	Receiver
Language	English