Denon AVR-2311CI User Manual

9
ENGLISH
Basic version Advanced version InformationSimple version
Set up speakers (Audyssey
®
Auto Setup)
STEP 4
Calculation
STEP 5
Check
11
2Q WKH
STEP 3
 VFUHHQ XVH ui
WR VHOHFW ³1H[W 1 &DOFXODWLRQ´ DQG
WKHQSUHVV
ENTER
Measuring results are analyzed, and the
frequency response of each speaker in the
listening room is determined.
>@
$8726(783
$8'<66(<$8726(783
0XOW(4
67(3&DOFXODWLRQ
1RZFDOFXODWLQJ
3OHDVHZDLW

• Analysis takes several minutes to complete. The
time required for this analysis depends on the
number of speakers connected.
The more connected speakers there are, the
longer it takes to perform analysis.
Remote control operation
buttons
Move the cursor
(Up/Down/Left/Right)
Confirm the setting Return to previous menu
NOTE
• If the result differs from the actual connection
status, or if “Caution!” is displayed, see “Error
messages” (vpage10). Then carry out Audyssey
Auto Setup again.
• If the result still differs from the actual connection
status after remeasurement or the error message
still appears, it is possible that the speakers
are not connected properly. Turn this unit off,
check the speaker connections and repeat the
measurement process from the beginning.
• If you change speaker positions or orientation,
perform Audyssey Auto Setup again to find the
optimal equalizer settings.
12
8VHuiWRVHOHFWWKHLWHP\RXZDQW
WRFKHFNDQGWKHQSUHVV
ENTER
>@
67(3&KHFN
&KHFNSURFHVVLQJUHV
XOWV7RSURFHHGSUHVV
´1H[Wµ
6HOHFWLWHPWRFKHFN
6SNU&RQILJ&KHFN
'LVWDQFH&KHFN
&K/HYHO&KHFN
&URVVRYHU&KHFN
1H[W6WRUH
$8726(783
$8'<66(<$8726(783
0XOW(4
(17(5 (QWHU 5(7851 &DQFHO
• Subwoofers may measure a greater reported
distance than the actual distance due to added
electrical delay common in subwoofers.
• If you want to check another item, press
RETURN.
13
8VH ui WR VHOHFW ³1H[W 1 6WRUH´
DQGWKHQSUHVV
ENTER
STEP 6
Store
14
6HOHFW³6WRUH´DQGWKHQSUHVVENTER
Save the measurement results.
>@
$8726(783
$8'<66(<$8726(783
0XOW(4
67(36WRUH
1RZVWRULQJ
3OHDVHZDLW

>@
67(36WRUH
3UHVV´6WRUHµWRVWRUH
FDOFXODWLRQUHVXOWV
$SSO\DQGVWRUHPHDVXUHPHQWUHVXOW
6WRUH
$8726(783
$8'<66(<$8726(783
0XOW(4
(17(5 (QWHU 5(7851 &DQFHO
• Saving the results requires about 10 seconds.
• If the measuring results are not to be saved,
press
RETURN. A message “Cancel Auto
Setup?” will be displayed. Press o then select
“Yes”. All the measured Audyssey Auto Setup
data will be erased.
NOTE
During saving of measurement results, be sure
not to turn off the power.
Finish
NOTE
After performing Audyssey Auto Setup, do not
change the speaker connections or subwoofer
volume. In event of a change, perform Audyssey
Auto Setup again.
15
8QSOXJWKHVHWXSPLFURSKRQHIURP
WKHXQLW¶V6(7830,&MDFN
16
6HW'\QDPLF9ROXPH


>@
)LQLVK
6WRULQJFRPSOHWH
$XWR6HWXSLVQRZ
ILQLVKHG3OHDVHXQSOXJ
PLFURSKRQH
7XUQRQ'\QDPLF9ROXPH"
$8726(783
$8'<66(<$8726(783
0XOW(4
(17(5 ([LW
7XUQ'\QDPLF9ROXPHRQDQGH[LW$XWR6HWXS
<HV 1R
• For details of Dynamic Volume settings, see
page 55.
n When turning Dynamic Volume on
• Use o to select “Yes”, and then press ENTER.
The unit automatically enters “Evening” mode.
n When turning Dynamic Volume off
• Use p to select “No”, and then press ENTER.

Denon AVR-2311CI Specifications

General

Brand	Denon
Model	AVR-2311CI
Category	Stereo Receiver
Language	English