AVR-2802/982
13
CAUTION IN SERVICING
Initializing AV SURROUND RECEIVER
AV SURROUND RECEIVER initialization should be performed when the µcom, peripheral parts of µcom, and DSP
P.W.B. are replaced.
1. Switch off the unit and remove the AC cord from the
wall outlet.
2. Hold the following A button and B button, and plug
the AC cord into the outlet.
3. Check that the entire display is flashing with an
interval of about 1 second, and release your fingers
from the 2 buttons and the microprocessor will be
initialized.
Note: If step 3 does not work, start over from step 1.
All user settings will be lost and its factory setting will be recovered when this initialization mode.
So make sure to memorize your setting for restoring after the initialization.
2
VOLUME LEVEL
AUTO
LOCK
STAND BY
DIGITAL
PCM
SIGNAL
DIGITAL
INPUT
REMOTE
SENSOR
To Next Page
Loading...
Need help?
General
