EasyManuals Logo
Home>Denon>Stereo Receiver>AVR-3300

Denon AVR-3300 User Manual

Denon AVR-3300
62 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #52 background imageLoading...
Page #52 background image
52
ENGLISH
Surround parameters w
ROOM SIZE:
This sets the size of the sound field.
There are five settings: “small”, “med.s” (medium-small), “medium”, “med.l” (medium-large) and “large”. “small” recreates a small sound
field, “large” a large sound field.
EFFECT LEVEL:
This sets the strength of the surround effect.
The level can be set in 15 steps from 1 to 15. Lower the level if the sound seems distorted.
DELAY TIME:
In the matrix mode only, the delay time can be set within the range of 0 to 300 ms.
TONE CONTROL:
This can be set individually for the separate surround modes other than Direct.
2 Surround modes and parameters
C: Signal/adjustable
D: Selected by speaker configuration setting
B: Turned on or off by speaker configuration setting
E: No signal/not adjustable
(Note) When playing Dolby Digital Signal : –10 dB
When playing DTS Signal : –10 dB
12
LISTENING TO THE RADIO
Setting the frequency step (for multiple voltage model only)
The tuning frequency steps are switchable between 9 kHz and 10 kHz for AM, between 0.05 MHz and 0.2 MHz for FM. To switch the tuning
frequency steps, disconnect the power plug and set the FREQ. STEP switch on the rear panel to the desired position. Then plug in the AC main
again.
9kHz
10kHz
FREQ. STEP
TABLE OF TUNING FREQUENCY STEPS
BAND FM
0.05 MHz
0.20 MHz
AM
09 kHz
10 kHz
STEP (FREQ. STEP): 09 kHz
STEP (FREQ. STEP): 10 kHz
The know the tuning frequency steps see the Tuning Frequency Steps
Signals and adjustability in the different modes
Channel output Parameter (default values are shown in parentheses)
TONE
CONTROL
CINEMA
EQ.
ROOM
SIZE
EFFECT
LEVEL
DELAY
TIME
When playing Dolby
Digital/DTS signals
D. COMP LFE
FRONT
L/R
CENTER
SURROUND
L/R
SUB-
WOOFER
EFFECT
L/R
DIRECT
STEREO
6CH/8CH EXTERNAL INPUT
DOLBY PRO LOGIC
DOLBY DIGITAL
DTS SURROUND
5CH STEREO
ROCK ARENA
JAZZ CLUB
VIDEO GAME
MONO MOVIE
MATRIX
C
C
C
C
C
C
C
C
C
C
C
C
E
E
B
B
B
B
B
B
B
B
B
B
E
E
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
E
E
C
E
E
E
E
E
E
E
E
E
E
C (0dB)
C (0dB)
C (0dB)
C (0dB)
C (0dB)
C (0dB)
C (0dB)
C (0dB)
C (0dB)
C (0dB)
C (0dB)
E
E
E
C (OFF)
C (OFF)
C (OFF)
E
E
E
E
E
E
E
E
E
E
E
E
E
C (Medium)
C (Medium)
C (Medium)
C (Medium)
E
E
E
E
E
E
E
E
C (10)
C (10)
C (10)
C (10)
E
E
E
E
E
E
E
E
E
E
E
E
C (30msec)
C (OFF)
C (OFF)
E
C (OFF)
C (OFF)
C (OFF)
E
E
E
E
E
E
C (Note)
C (Note)
E
C (0dB)
C (Note)
C (Note)
E
E
E
E
E
E
Mode

Other manuals for Denon AVR-3300

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-3300 and is the answer not in the manual?

Denon AVR-3300 Specifications

Audio Specifications IconAudio Specifications
rated output (front)105 W + 105 W (8 Ω, 20 Hz ~ 20 kHz with 0.05% T.H.D.)
rated output (center)105 W (8 Ω, 20 Hz ~ 20 kHz with 0.05% T.H.D.)
dynamic power140 W x 2 ch (8 Ω)
input sensitivity / input impedance200 mV / 47 kΩ
frequency response (analog)10 Hz ~ 50 kHz: +0, –3 dB (DIRECT mode)
S/N (analog)102 dB (DIRECT mode)
distortion (analog)0.01% (20 Hz ~ 20 kHz) (DIRECT mode)
D/A output (rated)2 V (at 0 dB playback)
total harmonic distortion (digital)0.008% (1 kHz, at 0 dB)
S/N ratio (digital)102 dB
dynamic range (digital)96 dB
phono input sensitivity2.5 mV
RIAA deviation±1 dB (20 Hz to 20 kHz)
signal-to-noise ratio (phono)74 dB (A weighting, with 5 mV input)
distortion factor (phono)0.03% (1 kHz, 3 V)
Video Specifications IconVideo Specifications
input / output level and impedance (standard video)1 Vp-p, 75 Ω
frequency response (standard video)5 Hz ~ 10 MHz — +0, –3 dB
input / output level and impedance (S-video)Y signal — 1 Vp-p, 75 Ω; C signal — 0.286 Vp-p, 75 Ω
frequency response (S-video)5 Hz ~ 10 MHz — +0, –3 dB
input / output level and impedance (color component video)Y signal — 1 Vp-p, 75 Ω; Cb/Cr signal — 0.7 Vp-p, 75 Ω
frequency response (color component video)5 Hz ~ 20 MHz — +0, –3 dB
Tuner Specifications IconTuner Specifications
receiving range (FM)87.50 MHz ~ 107.90 MHz
receiving range (AM)520 kHz ~ 1710 kHz
usable sensitivity (FM)1.0 µV (11.2 dBf)
50 dB quieting sensitivity (MONO)1.6 µV (15.3 dBf)
S/N (IHF-A) (MONO)80 dB
total harmonic distortion (MONO)0.15% (at 1 kHz)
General Specifications IconGeneral Specifications
power supply (North America model)AC 120 V, 60 Hz
power consumption (North America model)5.6 A
maximum external dimensions434 (W) x 171 (H) x 416 (D) mm
weight15.0 kg (33 lbs 2 oz)
batteries (remote control)R6P/AA Type (two batteries)
external dimensions (remote control)70 (W) x 215 (H) x 24 (D) mm
weight (remote control)200 g (Approx. 7 oz) (including batteries)

Related product manuals