To limit the Video/Audio output try the (EDID) or HDCP method to properly display picture on the TV and to correct sound issues.
Limit Mode Menu
The AV Receiver has various options for Limit Mode.
These limit modes are stored for each Video input source.
0
Front panel display sample (e.g.AVR-X2400H)
.
Item Description
1 Source Select
(Source)
The input source can be changed from this menu.
2 Max Resolution
(MaxRes.)
Sets the video input/output resolution restrictions supported by
the AV receiver.
3 HDCP2.2
(HDCP)
This sets the HDCP limit of the AV Receiver to HDCP ver. 1.4.
This can be set for any input with HDMI assigned to it.
4 HDR
This limits (disables) the HDR capability of the AV Receiver.
This can be set for any input with HDMI assigned to it.
5 Deep Color
(DeepC)
This limits (disables) Deep Color capability of the AV
Receiver.
This can be set for any input with HDMI assigned to it.
6 Dolby Vision
(DolbyV)
This limits (disables) the Dolby Vision capability of the AV
Receiver.
This can be set for any input with HDMI assigned to it.
7 DTS:X This limits (disables) DTS:X capability.
This can be set for any input with HDMI assigned to it.
Item Description
8 Dolby Atmos
(Atmos)
This limits (disables) Dolby Atmos capability.
This can be set for any input with HDMI assigned to it.
9 PCM 2ch only
(PCM2ch)
This limits the audio input capability to PCM 2ch only.
This can be set for any input with HDMI assigned to it.
When PCM 2ch only is set, DTS:X and Dolby Atmos are also
restricted.
10 Reset The setting content of Limit Mode is initialized.
11 Exit Exit Limit Mode and return to HDMI DIAGNOSTICS mode.
Source Selection
You can switch inputs to check other video sources.
The input source encoder on the unit or remote control unit can be used to change
the input source.
When the current input source is audio only, with no video assignment, "Audio" is
displayed.
Introduction How to operate Cable Test Limit mode Log & EDID Troubleshooting
12
To Next Page
Loading...
Need help?
General
