Initialization
The Limit setting in the HDMI DIAGNOSTICS mode is stored per input.
Please note that the limit mode settings backup memory will not be initialized (reset) using the initialization (reset) method described in the instruction manual.
There are two ways to reset the limit mode settings.
Reset option in HDMI DIAGNOSTICS mode
Limit mode settings that are made in the HDMI Diagnostics mode are reset to the
factory default values.
However, settings other than HDMI Diagnostics (e.g. Speaker setup, Video Setup,
Audio Setup) are not reset.
1
Select "5 Limit Mode" from the HDMI Diagnostics menu.
2
Select "Reset" from the Limit mode menu.
3
Select ”All source", then press ENTER.
Factory Reset mode
All settings including the Limit mode setting of HDMI Diagnostics mode are reset to
the factory default values. (except for Network setup)
1
Press the POWER button to turn off the AV Receiver.
2
While holding down buttons [A] and [B] simultaneously, press
POWER button.
3
Release the buttons after confirming that the front panel display
flashes at 1-second intervals.
Model Button [A] Button [B]
AVR-S730H
AVR-S930H
TUNER
PRESET CH +
TUNE -
AVR-X1400H
AVR-X2400H
ZONE2 SOURCE DIMMER
Introduction How to operate Cable Test Limit mode Log & EDID Troubleshooting
8
To Next Page
Loading...
Need help?
General
