©2021 ITW EAE. All rights reserved. Despatch is a registered trademark in the U.S. and other
countries. No part of the contents of this manual may be reproduced, copied or transmitted in any form
or by any means without the written permission from ITW EAE - Despatch, unless for purchaser's
personal use.
3. SAFETY
3.1. General Safety Information
Do not work on the LCC/LCD Series oven without reading and understanding this
section which contains important information and warnings. Ignoring these
warnings can result in death, serious injury or damage to the machine and
product.
3.2. Lockout
Machine lockout places the LCC/LCD Series oven into a zero-energy state and
prevents accidental machine start up. Always follow the Lockout Procedure
described in this Section before cleaning, maintaining, or repairing the LCC/LCD
Series oven. An accidental start-up, while working on the LCC/LCD Series oven,
can result in serious injury or death.
3.2.1. Lockout Requirements
1. Every power source that can energize any element of the LCC/LCD Series
oven must be shut off at the closest possible power source. This includes
air, water, and electricity, including the Disconnect Switch.
2. After energy sources are locked out, test to ensure circuits are de-energized.
3.2.2. Lockout Procedure
Personnel authorized to lockout equipment must have the necessary locks to
perform the lockout.
1. Physically disconnect all electrical power to the machine or lockout the
appropriate breaker or disconnects.
2. Close all valves and bleed off any pressure.
3. Test for power by attempting a start with the machine controls.
4. Identify the Lockout Condition with a tag on the electrical disconnect and
pneumatic shut off valve.
5. When work is complete, remove all tags and restore the machine to its
working state.
To Next Page
Loading...
Need help?
General
