Step 4 - Fitting an AC cable protection cap to the end of the AC cable
Step 5 - Connecting the Microinverter to the PV modules
NOTE:
If AC power is already present when the DC cables are plugged in, the microinverter
should immediately flash red and start working within the set time (standard 60
seconds). If no AC power is present, the red light will flash three times quickly and
repeat after one second until AC power is connected.
Operating instructions for the Microinverter system
Operation of the microinverter PV system:
1.
switch on the AC line circuit breaker on each AC branch circuit of the micro
inverter.
2.
switch on the main AC circuit breaker of the utility grid. Your system will start
generating power af ter a one-minute wait.
DEYE SUN microinverter
User manual
- 10
To Next Page
Loading...
Need help?
General
