Configure the AnywhereUSB Manager from the command line group info
AnywhereUSB® Plus User Guide
97
group info
Purpose
Displays information about a group. For more information, see AnywhereUSBManager Group Status
pane.
Syntax
>awusbmanager group info,[
address
]
The [address] is the address of the group for which you want to display information. The address is
required.
Examples
Run the list command to determine the group's address.
AnywhereUSB Manager, below are the available devices:
AW02-000001 "HUB-000001" (AW02-000001.local.:18574)
* Group 2 "Admin group" (AW02-000001.2) (In-use by you)
Group 1 (AW02-000001.1) (In-use by you)
U3 Cruzer Micro (AW02-000001.1101)
* means Autoconnect enabled, + means Autoconnect inherited
Auto-Find: enabled
Autoconnect All: disabled
AnywhereUSB Manager not running as a service
Run the group info command.
>awusbmanager group info,AW02-000001.2
Information about the group displays.
ADDRESS: AW02-000001.2
LOCALNAME: Admin group
GROUP: 2
NAME: Group 2
PORTS: 2
AUTOCONNECT: enabled
IN USE BY: YOU
To Next Page
Loading...
Need help?
General