Digikeijs DK50018 User Manual

DK50018 - Bluetooth accessory and switching decoder Bluetooth connecon
DK50018 - Bluetooth accessory and switching decoder
www.digikeijs.com
*R-Bus, B-Bus are registered trademarks of Modelleisenbhan GmbH. XpressNet and RS-Bus are registered trademarks of Lenz 19www.digikeijs.com
3.1.8 Load preset per output
Within the load preset per output secon you can easily set up a specic preset per output.
In the past this could only be done by extensive cv programming but now you can very eas-
ily do this through the app and load preset per output process.
Step 1
Enter the start address you want to use, this can be any address number between 1 and
2048 but please keep in mind that every preset has a set number of needed addresses so
this could limit your start number when you go higher than number 2033. The app is smart
and will tell you when you need to change the start address. You can nd more informaon
on the presets and set of addresses on the preset informaon page in this document.
Step 2
Select the preset you want (1), the preset screen will now open. You can select the address
you want to use within the range available based on the start address given in step 1. Aer
that you can select to which output the selected device is connected (3). If you want the
same addresses to control mulple outputs you can select mulple outputs, if you want
separate addresses per output you only select one and add mulple presets in the rst
screen. When you have selected the address you want to use, the output which the device
is connected to you can select the Save buon and you can setup the next preset. The app
is build in a way that you can only select the addresses, outputs and for signals the groups
that are sll available and are not used yet.
Step 3
When you are done with seng up your presets per output please select the Congure de-
vice opon (4). You will be asked to give the new conguraon a name. (5) This can be any-
thing you want. When selecng OK the App will congure the device. When done the app
will show the conguraon page (6), from there you can, congure the device again, edit
the conguraon, remove the conguraon or open the switchboard.

Digikeijs DK50018 Specifications

General

Brand	Digikeijs
Model	DK50018
Category	Media Converter
Language	English