DK50018 - Bluetooth accessory and switching decoder Bluetooth connecon
DK50018 - Bluetooth accessory and switching decoder
www.digikeijs.com
*R-Bus, B-Bus are registered trademarks of Modelleisenbhan GmbH. XpressNet and RS-Bus are registered trademarks of Lenz 6 www.digikeijs.com
www.digikeijs.com
www.digikeijs.com
2.1 Technical specicaons
The connecon terminals for power and signal (track voltage) are designed for a cross-secon of 0.5mm². The terminals for Out 1-8 are designed for a cross-
secon of 0.34mm². Each Out (1-8) consists of two outputs. The terminal with the designaon "C" is always the common pole and always carries (+) potenal.
Terminals 1-18 are the respecve outputs and always carry (-) potenal. The DK50018 switches to minus (-). Bluetooth can be used throug the Digikeijs app
which you can nd in the iOS apple store or Android google play store. Firmware updates are only possible via the Digikeijs App. The DK50018 has build in
short circuit protecon to protect it’s outputs and connected devices. When their is a short cicruit the red led will burn unll the short circuit is resolved.
DCC
MM
DK50018
Number of
outputs
Protocol
Maximum load
per output
Total load
Supported
Power supply
Dimensions in
mm L X W X H
Bleutooth
16 X outputs
OUT1-OUT8
GROUP 1– 4
3A
3A
12-24 V DC Ideally
12 DC/3A or DCC
rail current
87 x 80 x 22
BLE 4.1
Note on selecng a power supply
When using "old" transformers (AC output), malfuncons may occur during opera4on under certain circumstances. When using a
transformer, it must also be noted that the output voltage of the transformer must be mulplied by 1.4 and therefore a higher
voltage is applied to the output of the DR4018 than to the input (power). For this reason we generally recommend the use of
switching power supplies with at least 12V (DC) output voltage (DC voltage) and 3A output power at maximum load of the outputs.
To Next Page
Loading...
Need help?
General
