Digikeijs DK50018 User Manual

DK50018 - Bluetooth accessory and switching decoder Bluetooth connecon
DK50018 - Bluetooth accessory and switching decoder
www.digikeijs.com
*R-Bus, B-Bus are registered trademarks of Modelleisenbhan GmbH. XpressNet and RS-Bus are registered trademarks of Lenz 26www.digikeijs.com
www.digikeijs.com
4.1.5 Mulmaus—POM programming
In the following example we will program the DK50018 to use preset 2 using
CV47— Value 2
1. Connect the DK50018 to the Z21 main track output.
2. We create a new locomove in the Mulmaus with the address 9999.
3. Enter the name of the new locomove for example ,,LOK1” and
press ,,OK”
4. Press both eraser keys on the Mulmaus simultaneously to select the
newly created locomove
5. Press the program buon on the DK50018. The yellow LED on the
DK50018 should be lit.
6. Simultaneously press the arrow and "Menu" buons to enter the
the programming menu. Please make sure POM mode is selected.
7. Select the CV modicaon opon and enter CV 47 and press ,,OK”
8. Enter the desired value, in this case 2 and select ,,OK” again.
9 You have now change to preset 2, please close the programming mode by
pushing the program buon on the DK50018. The yellow led will go o.
*:POM stands for Program On the Main and corresponds to the direct programming on the trac lane or "Track output" of the control unit.

Digikeijs DK50018 Specifications

General

Brand	Digikeijs
Model	DK50018
Category	Media Converter
Language	English