The information contained here are property of DIGITAX Automotive Electronics Italy, and extremely confidential. Any disclosure, copying, distribution to third party
is strictly prohibited.
"E-Seal"- Electronic Sealing: 1st Section
The “E-Seal” is a non-erasable memory in two sections where, in the first section, are recorded the last 100
alterations made on the programming functions. These are shown on the displays or printed, with detailed
information of: index nr, event, date, year and hour. The second section is made of permanent, non-resettable,
progressive individual events counter, incremented by each event alterations without details. The first section is
by default a FIFO buffer, with the last 100 events recorded, but can be configured if approved by some country
specific settings to disable the FIFO and block the taximeter when it reaches its maximum capacity. The second
sections (counters) is never FIFO, and when reaches its maximum capacity of 1000 events on any counter, the
taximeter shows “ESEAL FULL” and it is blocked until the mechanical seal is broken and the taximeter is again
initialized.
ESeal Auto-Default due to structure corruption
Statistical Memory block 2 reset
Manual Taximeter General Default
The "E-Seal" Reading is included in a multi menu. This is the procedure to enter it:
1) Select FOR HIRE position
2) Keep pressed K2 to enter in the menu selection
3) Select E-Seal menu by pressing K2 key multiple times
4) Confirm by K4 the E-Seal reading.
Now the first Record is showed on the display (see figure 1)
To increase the record index press K4
To decrease the record index press K3
To print the on reading menu press K1 (switch on the printer)
1
st
SECTION
This section shows the events list. For each record, the secondary display consecutively shows date, year and
time and, depending on record type, an additional info: the K Constant for Autotest events, the tariff CRC for
Tariff changes, the bios CRC for Bios changes, the ticket CRC for Ticket changes.