About the RP200
The Presets
Presets are named and numbered locations of programmed sounds which reside in the RP200.
Presets are recalled with the Footswitches.The active effects in each Preset will be indicated by
the lighted LEDs in the Effect Matrix.The RP200 comes with 40 User Presets (Presets 1-40) and
40 Factory Presets (Presets 41-80).The User Presets are locations where your creations may be
stored.The Factory Presets will not allow you to store any changes to them. From the factory,
the 40 User Presets are exact duplicates of the 40 Factory Presets.This allows you to create
your own Presets without the worry of losing any of the sounds that came with the RP200.
Performance Mode
When you first apply power to the RP200,it will power up in Performance mode. Performance
mode provides access to all of the Presets within the RP200 via the Up and Down
Footswitches.The Parameter 1 (left) knob will adjust the Amp Type,the Parameter 2
(middle) knob will select the Amp Gain (distortion),and the Parameter 3 (right) knob will
adjust the Master Level (volume).
Bypass Mode
The RP200 Presets can be bypassed for a clean,unprocessed guitar tone.To bypass the RP200,
press both Footswitches simultaneously.The Display will read Bypass indicating the Preset is
bypassed.Pressing either Footswitch will exit Bypass and return the RP200 to the last Preset
used.
9
To Next Page
Loading...
Need help?
General
