Effects
The Effects row in the RP200 is a multi-function module, allowing you to select effects such as;
Chorus,Flanger, Phaser,Tremolo, Panner,Vibrato,Rotary Speaker,YaYa™,AutoYa™, SynthTalk™,
Envelope Filter (auto wah), Detune,Pitch Shift,and Whammy™ effects. When the Effects row is
selected,the Parameter 1 knob is used to choose the type of Effect or turn the Effect module
off (eff Of).Only one of the effects in this row can be used at a time.After selecting the type
of effect in this module, the Parameter 2 and Parameter 3 knobs can then be used to adjust
the individual parameters associated with the selected effect.The following list describes each
Effect and their Parameters in more detail:
Chorus (CHORUS)
A Chorus adds a short delay to your signal.The delayed signal is modulated in and out of tune
and then mixed back with the original signal to create a thicker sound.
Amount -The Parameter 2 knob simultaneously adjusts the rate (Speed) and intensity
(Depth) of the modulation.Ranges from 1 to 99.
Level -The Parameter 3 knob controls the mix level of the Effect.Ranges from 0 to 99.
Flange (FLaNge)
A Flanger uses the same principle as a Chorus but uses a shorter delay time and adds
regeneration (or repeats) to the modulating delay.This results in an exaggerated up and down
sweeping motion to the effect.
Amount -The Parameter 2 knob simultaneously adjusts the rate (Speed) and intensity
(Depth) of the Effect.Ranges from 1 to 99.
Level -The Parameter 3 knob controls the mix level of the Effect.Ranges from 0 to 99.
20
To Next Page
Loading...
Need help?
General
