To Next Page

To Previous Page

• Press the <EQ/Gate> button once and the display will briefly read:

• Now to make adjustments to the four different EQ parameters use the <Parameter 1-4> buttons. Parameter and value

range for each is listed below.

Parameter 1 - Lo EQ - Range for the Low EQ is from -12 to +12 dB.

Parameter 2 - Parametric Frequency - Range for the Parametric Frequency is from 1 to 26.

Parameter 3 - Parametric Level - Range for the Parametric Level is from -12 to +12 dB.

Parameter 4 - Hi EQ - Range for the High EQ is from -12 to +12 dB.

• To modify any one these four parameters, simply press the respective <Parameter> button and then turn the

<Program/Data> wheel.

• Once the modifications are done, remember to store any changes and press the <Program> button to return to

Program mode.

Adjusting the Noise Gate

The S-100 gives you the ability custom tailor the Noise gate parameters (Threshold and Release) for each program by

performing the following procedure:

• Press the <EQ/Gate> button twice. The display will appear something like this, indicating that you are in Noise Gate

edit mode:

• Now press the <Parameter 1> button and th will appear prompting you to adjust the Noise gate Threshold by

turning the <Program/Data> wheel. The range for the Noise gate Threshold is from Off, 99 to 0.

• To adjust the Noise Gate Release , press the <Parameter 2 > and the display will read: rE, prompting you to use the

<Program/Data> wheel to adjust the Noise Gate Release parameter. Release range is from 1 to 10.

• Once all Noise gate modifications have been made, remember to store the changes and press the <Program> button to

return to program mode.

S-100

User Guide

Section -2 Operation and Editing

DigiTech S100 User Manual

Questions and Answers: