A Quick Tour of the S-100
The Front Panel
1) Configuration Matrix - This matrix shows the five different effect configurations available in the S-100.
2) Input Meter/ Effect Display - In Program mode, this meter displays the input signal entering the unit. In Edit mode, it
will indicate which effect is being used.
3) Number Display - In Program mode, this number display will indicate program number (decimal point indicates a user
program). In Edit mode, the display will indicate effects and parameter values.
4) Program/Data Wheel - In Program mode, this wheel is used to change programs and when the unit is in Edit mode it is
used to select effects and change parameter.
5) Program Button -This button returns the S-100 to program mode when pressed.
6) Store Button - This button is used to store program modifications in the S-100.
7) Configuration Button - This button is used to select Configuration mode. Once pressed, use the <Program/Data>
wheel to select a different effect configuration for the selected program.
8) Mix/MIDI - This button is used to turn the Dry signal path On and Off and select the MIDI channel that program change
information is received on.
9 a
~
g) Program Editing buttons - These seven buttons are used to make key editing modifications to the S-100 and their
functions are as follows:
9-a) EQ/Gate - This button (in conjunction with the four parameter buttons) are used to adjust the three band EQ and
Noise gate threshold and release. Press once to select the EQ and press twice to select the noise gate.
9-b) Engine A - This button selects the Engine A effect module. Once this button is pressed, use the <Program/Data>
1 2
3 4
5 106 7
8
9 a~g
Other Other
Reverb Reverb
Delay Delay
Predelay
Decay LevelSize
Mod/Pitch
LR
Mod/Pitch
23
C1 C2
C3
C4
C5
S-100
User Guide
5
Section -1 Introduction
To Next Page
Loading...
Need help?
General
