Editing Engine A and B Modules
Because of its processing power, the S-100 gives you two Engine modules that are fully programmable. The following section
explains the simple procedure for Engine A and B editing.
Selecting and Editing Effects
• From Program mode, press either the <Engine A> or <Engine B> button. The current type of effect will light the
corresponding LED in the effect display and it’s two letter abbreviation will appear in the number display looking
something like this:
Note- In order to edit Engine B, configurations 2-5 must be used.
• Now turn the <Program/Data> wheel to select the effect to be used. The effect display’s LED and number display’s
abbreviation will change as the new effects are selected.
• Once the effect to be used has been selected, you can use the <Parameter 1-4> edit buttons to modify the parameters
of the selected effect.
For a complete list of the effects available and their respective names, please see Section 3 on pages 13-16.
• Once all of the edits have been made to the selected program, make sure to store any changes and then press the
<Program> button to return to the Program mode.
Other Other
Reverb Reverb
Delay Delay
Mod/Pitch
LR
Mod/Pitch
rs
User Guide
12
S-100
Section -2 Operation and Editing
To Next Page
Loading...
Need help?
General
