The Rear Panel
1) Input Level- This knob controls the level of signal entering the S-100. For optimal performance, set this level so the
Input level indicators (located on the front panel) occasionally light the red LEDs.
2) Left/Mono Input - This Input jack is used for the Left or Mono input. When only the Left input jack is used, the signal is
sent to both Left and Right S-100 inputs.
3) Right Input - This is the Right Input jack for the S-100 that when used with Left input will preserve stereo imaging.
4) Left/Mono Output - This is the S-100’s left audio output. This output must be used if a mono effect
is desired.
5) Right Output - This is the S-100’s right audio output. Use both left and right outputs to take
advantage of stereo effects.
6) AC Line Input - This is the AC adapter receptacle. Use only the included PS 750 power supply.
7) Footswitch Jack - This jack is used for the insertion of the Digitech FS-300 footswitch that will control program changes
and Bypass the digital effects of the S-100.
8) MIDI IN - This MIDI jack is used for receiving MIDI program change and CC information.
INPUT LEVEL
LEFT/MONO
IN
RIGHT IN
LEFT/MONO
OUT
RIGHT OUT
POWER SUPPLY
FOOTSWITCH MIDI IN
1
2 3
4 5
6
7
8
S-100
User Guide
7
Section -1 Introduction
To Next Page
Loading...
Need help?
General
