DigiTech S100 User Manual

wheel to change the effect used in this module.
9-c) Engine B - This button selects the Engine B effect module. Once this button has been pressed, use the
<Program/Data> wheel to change the effect used in the module.
9-d) Parameter 1 / Predelay - This button selects parameter 1 for editing in conjunction with the <Program/Data>
wheel. It is also the Predelay parameter of the Reverb effect.
9-e) Parameter 2 / Decay - This button selects parameter 2 for editing in conjunction with the <Program/Data>
wheel. It is also the Decay parameter of the Reverb effect.
9-f) Parameter 3 / Damping - This button selects parameter 3 for editing in conjunction with the <Program/Data>
wheel. It is also the Damping parameter of the Reverb effect.
9-g) Parameter 4 / Level - This selects parameter 4 (level) for editing in conjunction with the <Program/Data> wheel.
10) Bypass - This button is used to Bypass all of the digital effects in the S-100 and allow the original dry signal to pass
through the S-100.
User Guide
6
S-100
Section -1 Introduction

DigiTech S100 Specifications

General

Brand	DigiTech
Model	S100
Category	Recording Equipment
Language	English