Shure™ Green Bullet Large Diaphragm Dynamic - BULLET
Harmonica Mic
Brawner™ VM1 Large Diaphragm Condenser BRAWNY
Neumann™ M149 Large Diaphragm Condenser NEU149
Lawson™ L47MP Large Diaphragm Tube LAWLES
AKG™ 414 ULS Large Diaphragm Condenser SLVGRL
Sennheiser™ 421 MD Large Diaphragm Dynamic SENDYN
Audio Technica™ AT4050 Large Diaphragm Condenser ATCOND
Neumann™ KM184 Large Diaphragm Condenser NEU184
Scheops™ MK21 Small Diaphragm Condenser SHEP21
Shure™ KSM32 Large Diaphragm Condenser KISSEm
Shure,AKG, Audio Technica, Neumann, Lawson, Oktava, Royer, Brawner, Sennheiser, and Scheops are Registered trademarks of their respective companies. The aforementioned names and models are
used solely to indicate microphones used for analyzation in the development of this product. It is not implied in any way that there is any association with or endorsement by any of the named
manufacturers.
Compressor/Noise Gate
The Compressor/Noise Gate module is used to control the dynamics of varying signal strengths and
eliminate unwanted noise when a signal isn’t present.
Comp On/Off - The Number 1 Knob turns the Compressor on (On) and off (Of).
Amount - Rotate the Number 2 Knob to adjust the amount of Compression you want applied to the
signal. Ranges from 1 to 20.
Gain - Rotate the Number 3 Knob to increase the compressor’s output gain. Ranges from 0 to 10dB.
Gate Off/Threshold - Rotate the Number 4 Knob to turn the Noise Gate off (Of) and to adjust the
threshold level. Ranges from 1 to 99. A higher setting requires a stronger signal to
open the gate.
Mic Pre/Voice
This module selects various Mic Preamp and Voice character types. Tube Pre is a warm professional mic
preamp type for standard vocal usage. Overdrive and Grunge are cutting edge distortion preamp types.
The other nine voice characters produce wild and unnatural vocal sounds.
Voice Type/Off - The Number 1 Knob selects a vocal type and turn the Mic Pre/Voice types on (On) and
off (Of) (see Mic Pre/Voice Type Parameter chart following these for parameter
descriptions).
Parameter 1 - The Number 2 Knob adjusts the first parameter of the Voice type selected (see Voice
Parameter chart following these instructions).
Parameter 2 - The Number 3 Knob adjusts the second parameter of the Voice type selected (see Voice
Parameter chart following these instructions).
Level - The Number 4 knob controls the preset level for the selected type. Ranges from 0 to 99
Master Level - The Number 5 Knob controls the Vx400’s Master Level.
Mic Pre / Voice Parameters
Voice Type Param 1 Range Param 2 Range
Direct ---- ---- ------ ----
Tube Pre Gain 0-15 De Ess 1-50
Overdrive Gain 0-50 De Ess 1-50
Grunge Gain 0-50 De Ess 1-50
11
Creating Presets
To Next Page
Loading...
Need help?
General
