Dark Side Breath 1-20 ------ ----
Monster Size 1-60 Growl 1-40
Chipmunk Size 1-30 ------ ----
Lunar Range 1-10 ------ ----
Lo-Fi drive 0-50 Subfrq (Sub Freq.) 1-18
Robot Range 1-50 EdGE 1-50
Wizard Range 1-50 ------ ----
Alien RaTE 1-40 Intens (Intensity) 1-50
Telephone SubFRQ (Sub Freq.) 1-35 siblnc (Sibilance) 1-50
EQ
The EQ module is a 3-band EQ consisting of Bass, Midrange, and Treble.The frequency centers for each
band may vary depending on the selected model.
Bass - The Number 1 Knob adjusts the low frequency gain. Ranges from -12 to +12dB.
Midrange - The Number 2 Knob adjusts the midrange frequency gain. Ranges from -12 to +12dB.
Mid Frequency - The Number 3 Knob adjusts the midrange frequency. Ranges from 100Hz to 4000Hz.
Treble - The Number 4 Knob adjusts the high frequency gain. Ranges from -12 to +12dB
Mod Effects
The Effects row in the Vx400 is a multi-function module allowing you to select effects such as: Chorus,
Flanger, Phaser,Tremolo,Vibrato, Strobe, Doubler, Envelope, Pixelator, Detune, Pitch, and Whammy™
effects. When the Effects row is selected, the Number 1 Knob is used to turn the Effect module on or
off (
EFFECT OF), and select the type of Effect to be used. After selecting the type of effect in this
module, the Number 2-4 Knobs can then be used to adjust the individual Parameters associated with the
selected effect. The Number 5 Knob controls the Vx400’s Master Level. The following describes each
Effect and their Parameters in more detail:
Chorus
A Chorus adds a short delay to your signal. The delayed signal is modulated in and out of tune and
then mixed back with the original signal to create a thicker sound.
Parameter 1 -The Number 2 Knob adjusts the rate (Speed) of the modulation. Ranges from 1 to 99.
Parameter 2 - The Number 3 Knob adjusts the intensity (Depth) of the modulation. Ranges from 1
to 99.
FX Level - The Number 4 Knob controls the volume of the Chorus. Ranges from 0 to 99.
Master Level - The Number 5 Knob controls the Vx400’s Master Level.
Flanger
A Flanger uses the same principle as a Chorus but uses a shorter delay time and adds regeneration
(or repeats) to the modulating delay. This results in an exaggerated up and down sweeping motion to
the effect.
Parameter 1 - The Number 2 Knob adjusts the rate (Speed) of the modulation. Ranges from 1 to 99.
Parameter 2 - The Number 3 Knob adjusts the intensity (Depth) of the modulation. Ranges from 1
to 99.
FX Mix - The Number 4 Knob controls the mix of wet and dry signal. Ranges from 0 (all dry) to 99
(all wet).
12
Creating Presets