Dino-Power DP-X3 User Manual

13
How to Spray
Adjust Pressure Control
The pressure control knob allows for infinite pressure adjustment. To reduce overspray, always
start at the lowest pressure setting and increase pressure to the minimum setting that results
in an acceptable spray pattern.
2900 psi
(200 bar, 20 MPa)
1500 psi
(103 bar, 10.3 MPa)
500 psi
(34.5 bar, 3.5 MPa)
To select function, align symbol on pressure control knob with setting indicator on sprayer.
Tip and Pressure Selection
See table for recommended spray pressure for your material. Refer to paint (material) can for
manufacturer’s recommendations.
Maximum tip hole sizes supported by the sprayer:
DP-X3: 0.017 in. (0.43 mm)
DP-X6: 0.019 in. (0.48 mm)
Coatings
Interior
Stains/
Interior &
Exterior
Clears
Exterior
Solid Stains
Primers
Interior Latex
Paints
Exterior Latex
Paints
Spray Pressure
Low Spray
High Spray
High spray
High Spray
High Spray
Tip hole Size
0.011 in. (0.28 mm)
X
0.013 in. (0.33 mm)
X
X
X
X
0.015 in. (0.38 mm)
X
X
X
X
0.017 in. (0.43 mm)
X
X
X
0.019 in. (0.48 mm)
X
Spray Techniques
Use a piece of scrap cardboard to practice
these basic spraying techniques before you
begin spraying the surface.
• Hold gun 12 in. (30 cm) from surface
and aim straight at surface. Tilting gun
to direct spray angle causes an uneven
12 in.
(30 cm)
EVEN
FINISH
THICK
UNEVEN
FINISH
THIN
finish.
• Flex wrist to keep gun pointed straight.
Fanning gun to direct spray at angle
causes uneven finish.
EVEN FINISH THIN
THICK
THIN

Dino-Power DP-X3 Specifications

General

Brand	Dino-Power
Model	DP-X3
Category	Paint Sprayer
Language	English