Dino-Power DP-X3 User Manual

Reference
19
Reference
Spray Tip Selection
Selecting Tip Size
Spray tips come in a variety of hole sizes for
Understanding Tip Number
The last three digits of tip number (i.e.:413)
contain information about hole size and fan
width on surface when gun is held 12 in.
(30.5 cm) from surface being sprayed.
First digit when doubled
= approximate
413 tip has
spraying a range of fluids. Your sprayer
includes a tip for use in most paint spraying
applications. Use the coatings table on page
17 to determine the range of recommended
tip hole sizes for each fluid type. If you need
a tip other than the one supplied, see the
Reversible Spray Tip Selection Chart.
fan width.
8-10 in. (20-25 cm)
fan width.
413 tip has
a 0.013 in.
hole size
Hints:
• As you spray, the tip wears and
enlarges. Starting with a tip hole size
smaller than the maximum will allow
you to spray within the rated flow
capacity of the sprayer.
• Use larger tip hole sizes with thicker
coatings and smaller tip hole sizeswith
thinner coatings.
• Tips wear with use and need periodic
replacement.
• Tip hole size controls flow rate - the
amount of paint that comes out of the
gun.
Fan Width
Fan width is the size of the spray pattern,
which determines the area covered with each
stroke.
Hints:
• Select a fan width best suited to the
surface being sprayed.
• Wider fans allow provide better cover-
age on broad, open surfaces.
• Narrower fans provide better control on
small, confined surfaces.
Last two digits = tip hole size in thousands of an inch.
Reversible Spray Tip
Selection Chart
Tip #
Fan Width *
Hole Size
XT311
6 - 8 in.
(152 - 203 mm)
0.011 in.
(0.28 mm)
XT411
8 - 10 in.
(203 - 254 mm)
0.011 in.
(0.28 mm)
XT313
6 - 8 in.
(152 - 203 mm)
0.013 in.
(0.33 mm)
XT413
8 - 10 in.
(203 - 254 mm)
0.013 in.
(0.33 mm)
XT415
8 - 10 in.
(203 - 254 mm)
0.015 in.
(0.38 mm)
XT515
10 - 12 in.
(254 - 305 mm)
0.015 in.
(0.38 mm)
XT417
8 - 10 in.
(203 - 254 mm)
0.017 in.
(0.43 mm)
XT517
10 - 12 in.
(254 - 305 mm)
0.017 in.
(0.43 mm)
XT619
12 - 14 in.
(305 - 356 mm)
0.019 in.
(0.48 mm)
* – 12 in. (305 mm) from surface
Example: For an 8 to 10 in. (203 to 254 mm)
fan width and 0.013 (0.33 mm) hole size.

Dino-Power DP-X3 Specifications

General

Brand	Dino-Power
Model	DP-X3
Category	Paint Sprayer
Language	English