dji A3 User Manual

A3/A3Pro
User Manual
©
2016 DJI. All Rights Reserved.
35
Troubleshooting
1. LED Status checklist
Ensure the mode switch corresponds to the ight status LED.
Ensure the system status LEDs on the GPS-Compass Pro and IMU Pro are normal.
Ensure all the sensor parameters are correct and the IMUs are calibrated correctly.
2. IMU calibration failure.
Ensure the aircraft is not moved during calibration.
Ensure the aircraft is placed level during calibration.
3. Battery detection error.
Connect to DJI Assistant 2 to ensure the battery type is correct.
4. Compass calibration failure.
Restart the battery if compass calibration failed.
Connect to DJI Assistant 2 to ensure the channel mapping of the ight mode switch is correct.
Connect to DJI Assistant 2 to ensure the compass Mod value is normal.
5. Failed to exit the SD card read mode after reading the SD card successfully.
Restart the battery of the aircraft.
LED Indicator Status
Green
The module is functioning normally and working as a part of the system
When the LED is blinking green.
Red
The module is functioning abnormally When the LED is blinking red.
Blue
The module is functioning normally but not working as a part of the
system When the LED is blinking blue.
GPS-Compass Pro/IMU Pro/Flight Controller LED Indicator

dji A3 Specifications

Flight Performance

hovering accuracy (vertical)	±0.5 m
hovering accuracy (horizontal)	±2 m
max wind resistance	10 m/s
max yaw angular velocity	150°/s
max pitch angle	35°
max ascent velocity	6 m/s
max descent velocity	6 m/s

Power and Environment

power consumption	Max 21 W (Typical Value: 0.41 A @ 51 V)
operating temperature	14° to 113° F (-10° to 45° C)